Two coins can share the same date, the same mint mark and the same numerical grade, and still sit in very different places on a dealer’s price sheet. Look closely at the label and you’ll often find the reason tucked in after the number: two or three letters like FB, FS or DMPL. Those letters are coin strike designations, and for a handful of classic American series they matter almost as much as the grade itself.
This guide walks through what each common designation means, which coins can earn one, and why the two big grading services don’t always agree. If you’re still getting comfortable with the 1 to 70 scale, start with our primer on how coin grade affects value and come back here.
What coin strike designations actually measure
A grade describes how much a coin has worn and how many marks it picked up. A designation describes something different: how well the coin was made in the first place. When dies wore down or a press ran at low pressure, the highest points of a design never filled in completely. A coin can be fully uncirculated and still show a detail that never filled in.
PCGS sorts its designations into three families: color (for copper), strike, and surface reflectivity or contrast. The company is blunt about why they exist, writing that collector preferences “(and consequently market value) demand the use of Designations.”
Designations only apply to specific series. PCGS says it currently recognizes four strike designations across five series, so you won’t see Full Bands on a Washington quarter.
The four strike designations, one coin at a time
Full Bands (FB): Mercury and Roosevelt dimes
The reverse of the Mercury dime shows a fasces, a bundle of rods with an axe head, wrapped by three sets of twin horizontal bands. On a Full Bands coin the central bands are completely separated, with an unbroken line running between them. PCGS also looks beyond the middle pair, and dealers who handle these coins note that any interruption in the separation, even a nick or a gouge across the bands, disqualifies the coin.
Roosevelt dimes picked up the same idea later. PCGS began using Full Bands on business-strike Roosevelts on April 1, 2003, and its rule is that both the upper and lower pair of bands crossing the torch must be distinct, with “the line dividing the bands” complete and unbroken. NGC handles the same feature under its own name, Full Torch, which Numismatic News describes as fully separated top and bottom bands plus well-defined vertical lines on the torch.
Full Steps (FS): Jefferson nickels
Look at the base of Monticello on the reverse and you’ll see a short staircase. PCGS requires five separate step lines, clearly visible and running the full width of the building, for its FS designation. Any interruption in a step line rules a coin out, although a very slight weakness in a single step can still pass.
NGC splits the category in two. Since 2004 it has used 5FS and 6FS for Mint State Jefferson nickels, and any coin it designated FS before then is now counted as 6FS in its census. NGC also notes that full-step coins are easier to find early in the series and that strike quality “dropped significantly starting in 1950.” Proofs don’t get the designation at all, because full steps are simply expected on them.
Full Head (FH): Standing Liberty quarters
Hermon MacNeil’s Standing Liberty quarter has a reputation for weak heads, and the Full Head designation is where some of the largest premiums in the hobby live. PCGS uses different tests for the two design types. On Type I coins (1916 to 1917), it wants clear separation between Liberty’s hair cords and her cap. On Type II coins (1917 to 1930), it wants three complete and distinct leaves on the helmet, a complete outline along the bottom of the helmet, and a clear ear hole.
PCGS awards FH to qualifying coins grading AU50 or better, with an exception for the famous 1918/7-S overdate. It also cautions that not every Full Head coin is scarcer than its ordinary counterpart.
Full Bell Lines (FBL): Franklin half dollars
On the reverse of the Franklin half, the Liberty Bell carries horizontal lines across its lower section. For NGC’s FBL designation, all of those lines must be distinct, and NGC points out that the strike often leaves the lower lines incomplete. Both NGC and Numismatic News single out San Francisco halves as the hardest to find with full lines.
Here’s a good example of the services diverging. NGC says a Franklin doesn’t need to be Mint State to qualify, though most that do are. Numismatic News describes the requirement as MS60 or better. NGC also does not use FBL on proofs.
Prooflike, DMPL and the mirror designations
Reflectivity designations answer a different question: did the coin come off fresh dies with mirror-like fields? This is overwhelmingly a Morgan dollar story. PCGS designates Prooflike (PL) for coins grading MS60 or better that show clear mirrored surfaces “at a distance of two to four inches,” and Deep Mirror Prooflike (DMPL) for Morgans with deeply mirrored fields. As PCGS puts it, the difference between the two “is one of degree.”
NGC calls its top tier DPL and says plainly that it is equivalent to DMPL at other services. It also applies PL and DPL more broadly than PCGS, to any U.S. coin reflective enough to qualify, and assigns them automatically at no extra fee. The numbers show how uncommon true mirrors are: in a 2018 column, Jeff Garrett reported that about 2 percent of the Morgan dollars NGC had graded were Prooflike and less than 1 percent were Deep Prooflike. Peace dollars, by contrast, are “virtually unknown” with prooflike surfaces.
Proofs have their own version: PCGS uses Cameo (CAM) for light to moderate frosting on the devices and Deep Cameo (DCAM) for deep, even frosting, on both sides in each case.
How designations change what a coin is worth
The pattern across every designation is the same. A well-struck coin of a date that usually comes weak is the scarce version, and the market pays for scarcity. How much it pays depends entirely on the date, the mint and the grade. CoinWeek’s discussion of prooflike Morgans describes them as much rarer and considerably more expensive than their frosty counterparts, while PCGS’s own Full Head examples show some dates where the gap is modest and others where it’s enormous.
That’s also why population reports matter here. A census that separates FB from non-FB coins tells you how many of each actually exist in a given grade. Our guide to reading a coin price guide and population report explains how to use those numbers without overreading them.
Practical tips before you pay for the letters
- Check which service graded it. The criteria aren’t identical. A coin that misses at one company may qualify at the other, and the names differ (DMPL versus DPL, Full Bands versus Full Torch on Roosevelts).
- Verify the certification number. Both services let you look up a cert online.
- Look at the coin, not just the label. A designation is a pass or fail line. Two FB coins can still differ in how sharp the bands are and how attractive the coin is overall, which is the territory of eye appeal.
- Remember that melt is the floor. For a silver dime or half, the metal sets a minimum value. Everything a designation adds sits on top of that floor and depends on collector demand, which can cool as easily as it warms. Our how it works page explains how FMV Gold separates metal value from collector premium.
- Be wary of raw coins sold as “full bands” or “full steps.” Stickers add another layer, covered in our piece on what a CAC sticker means.
Coin strike designations aren’t a shortcut to a good deal, just a more precise vocabulary for a coin struck the way the engraver intended. If you’re browsing the series where these letters matter, the FMV Gold coin pages are a good place to see how the metal floor compares from coin to coin before collector premiums enter the picture.